C3 sleeve gear bearing

Here you can talk about all kind of TECH for the B50 B44 B25 And Other BSA unit Singles

Moderator: minetymenace

Post Reply
User avatar
FGF
>80
>80
Posts: 90
Joined: Sat May 11, 2019 3:14 pm
Location: Orleans
Has thanked: 23 times
Been thanked: 1 time
Flag: France

C3 sleeve gear bearing

Post by FGF » Wed Jul 29, 2020 3:36 pm

Hello ,

My sleeve gear ball bearing seem to be in good condition but the engine is fully stripped and the seal has to be changed.
The bearing rotate freely with the gearbox sprocket.

If i remove this bearing , do you advise me to fit a C3 bearing or a normal class bearing on the sleevegear ?
sleeve.jpg
sleeve.jpg (19.43 KiB) Viewed 340 times

And , bearing removed , the thrust washer B has to be changed too ?

User avatar
kommando
>1400
>1400
Posts: 1971
Joined: Mon May 24, 2004 8:41 pm
Location: Scotland
Has thanked: 10 times
Been thanked: 52 times
Flag: Ireland

Re: C3 sleeve gear bearing

Post by kommando » Thu Jul 30, 2020 7:33 am

C3, never changed a thrustwasher unless it was badly worn, as from the 1965 G series engine onward the mainshaft no longer moves with the clutch lever it does not wear.
These users thanked the author kommando for the post:
FGF (Thu Jul 30, 2020 10:15 am)
Rating: 25%

Post Reply