2MC Capacitors & Batteries

Moderator: minetymenace

Forum rules
Please write in easy English so everybody understand.
Post Reply
User avatar
b50root
Site Admin
Site Admin
Posts: 3314
Joined: Mon May 24, 2004 12:44 pm
Location: Malmö Scania Sweden
Has thanked: 64 times
Been thanked: 9 times
Flag: Scania Sweden
Contact:

2MC Capacitors & Batteries

Post by b50root » Mon Aug 10, 2009 6:12 am

2MC Capacitors & Batteries

Someone asked me, “I’m working on a 1970 BSA Thunderbolt and some people are telling
me that I need to fit a capacitor to the wiring harness to be 100% stock. Is this true? I want
my BSA to be a true restoration.”

The only capacitors that came stock on the 1970 BSAs were 2 ignition capacitors (aka
“ignition condensers”) under the seat. They are connected to the BLK/WHT and BLK/YEL
wires in parallel with the 2 ignition coils. On a 1970 model, both these capacitors live inside
a black rubber boot that is located under the seat.
Now this is probably the confusing part... so put on your bifocals and hearing aid, grandpa
and pay careful attention....

To meet US DOT law, all imported vehicles after about 1968 had to have a battery operated
headlamp and tail lamp (for safety reasons) just to get into the country. So all motorcycles
after 1968 came with a battery. This meant BSA and Triumph could no longer offer the ET
ignition on their "competition models". (This one law is why 1967 was the last year for so
many famous English models like the BSA Hornet and the Triumph T120 TT.)

However, riders still needed a way to simplify and lighten their bike for off-road and
competition. So to provide the battery operated lights to meet the law, and at the same time
make battery removal possible for the competition riders, all the stock models starting in
1968 came with a special wiring harness. Part of that special harness design was a 2-wire
pigtail that allowed you to connect the big, blue, Lucas 2MC capacitor if you intended to ride
competition. This pigtail can be found on all BSA and Triumph motorcycles from 1968 to
1970. Fitting the Lucas 2MC capacitor would thereby allow you to remove the battery and
steel brackets; a loss of about 15 lbs total.

Bottom line: The 1968 and later BSA and Triumphs were designed to run a battery on the
street OR a Lucas 2MC electrolytic capacitor for competition... but not both. It is electrically
possible to run both, but since they do the same job there is absolutely nothing to be gained.
So what was “showroom stock” on a BSA or Triumph was the battery only.
So what's probably troubling you is that you have this 2-wire “pigtail” back near the battery
and it goes nowhere. That is correct. For street riding, nothing gets connected to it. It's empty.
It's not used. It's vacant. It's free of connection. It's unfilled.
Hope this helps.

RF Whatley
Rodi British Bikes
http://www.gabma.us/
nebrer on EBAY
nebrer at skype ( http://www.skype.com )

Post Reply