liner machining

Here you can talk about all kind of TECH for the B50 B44 B25 And Other BSA unit Singles

Moderator: minetymenace

Post Reply
User avatar
FGF
>100
>100
Posts: 113
Joined: Sat May 11, 2019 3:14 pm
Location: Orleans

liner machining

Post by FGF »

Hello ,

with a B50 stock conrod ( 41-550 for B50-B44 ) is it usual to machine the cylinder liner like this ?
liner.jpg
Gerry answered me quickly and i thank him but
i 'd like to understand why the factory didn't design a suitable liner for it 's conrod ..

Changing conrod is not a '' plug and play '' way ?
Canberra
>1200
>1200
Posts: 1295
Joined: Fri Sep 03, 2004 11:45 am
Location: Canberra, Australia
Contact:

Re: liner machining

Post by Canberra »

Could it be the original hepolite piston had a long skirt. Maybe they needed the liner to be at a sufficient length but the con rod and bottom of the liner proved a conflict. That created the need for the cut outs on the lower sleeve. With modern short skirt pistons maybe the liner could be shorter and fully machined off?

Not possible to see the relationship when all is assembled but a CAD drawing may prove it can be shortened without an issue?

John
Post Reply